Pulley Belt Length and Wrap Angle
Calculate open belt length, small pulley wrap angle, and tension allowance checks from pulley diameters and center distance.
Calculate L10 and L10h from C, P, type, and rpm.
Enter bearing ratings and speed.
Basic rating life from the standard equation.
L10 (million rev)
15.63
L10h (hours)
173.61
Lna, adjusted life (million rev)
15.63
Lnah, adjusted life (hours)
173.61
Exponent p
3.000
Formulas used
L10 = (C / P)^p
L10h = (L10 * 10^6) / (60 * n)
Lna = a1 * L10
Lnah = a1 * L10h
Variables
Usage notes
After checking the basic result, open sharing, PDF, method notes, and comparison panels.
Calculates basic L10/L10h life from dynamic capacity C, equivalent load P, bearing type, and speed, then applies the a1 factor for an adjusted Lna estimate.
Basic L10 check
| Input | Expected Output |
|---|---|
| C=25 kN, P=10 kN, ball bearing, n=1500 rpm, a1=1 | L10=15.625 million revolutions; L10h≈173.6 hours |
Note: Cross-check the result against the actual load spectrum, manufacturer data, and project conditions.
Similar calculators
Explore calculators with similar categories or tags.
Calculate open belt length, small pulley wrap angle, and tension allowance checks from pulley diameters and center distance.
Find required fillet size from load, weld length, and allowable stress.
Analyze linear tolerance stacks with worst-case, RSS, and sensitivity contribution views.
Bending stress and max deflection for a simply supported beam.
Doc version: 1.1.0 | Updated: 2026-09-26
Enter bearing ratings and speed.
Basic rating life from the standard equation.
L10 (million rev)
15.63
L10h (hours)
173.61
Lna, adjusted life (million rev)
15.63
Lnah, adjusted life (hours)
173.61
Exponent p
3.000
Formulas used
L10 = (C / P)^p
L10h = (L10 * 10^6) / (60 * n)
Lna = a1 * L10
Lnah = a1 * L10h
Variables
Usage notes
After checking the basic result, open sharing, PDF, method notes, and comparison panels.
Calculates basic L10/L10h life from dynamic capacity C, equivalent load P, bearing type, and speed, then applies the a1 factor for an adjusted Lna estimate.
Basic L10 check
| Input | Expected Output |
|---|---|
| C=25 kN, P=10 kN, ball bearing, n=1500 rpm, a1=1 | L10=15.625 million revolutions; L10h≈173.6 hours |
Note: Cross-check the result against the actual load spectrum, manufacturer data, and project conditions.
L10 = (C / P)^p | L10h = (L10 x 10^6) / (60 x n) | Lna = a1 x L10 | p = 3 for ball bearings; p = 10/3 for roller bearingsLast updated: 2026-09-26
References
Assumptions
Guides
Browse guides with similar tags.
High-cycle fatigue analysis, S-N Wöhler curves, Marin modification factors, Goodman failure criterion, and Miner cumulative damage rule.
Systematic bearing selection guide combining load type, speed, temperature, and service conditions with ISO 281 L10 life calculation. SKF, FAG, and ISO 15312 referenced.