Skip to content
Calculator tabs
Sealing SystemsEngineering Guide

Seals & Gaskets Selection Guide

Filter standard elastomers, engineering plastics, and metallic gaskets based on operating fluid, operating temperature, and system pressure. Engineering guidance for hydraulic, pneumatic, and process piping design.

Operating Parameters

Design Tip: At 40+ bar, use contoured PTFE back-up rings to avoid radial extrusion. For steam systems verify peroxide-cured EPDM or specialized fluoroelastomers. Request FDA/EC1935 certificates for sanitary applications.

Recommended Seal & Gasket Materials

NBR (Nitrile Butadiene)

Styles: O-rings, V-rings, rotary shaft oil seals

Excellent compatibility with mineral oils, petroleum greases, and fuels; cost-effective general-purpose elastomer.

Poor ozone/UV weather resistance; typical operational range -30°C to +100°C.

HNBR (Hydrogenated Nitrile)

Styles: High-pressure O-rings, dynamic hydraulic packings

Higher mechanical strength, oil/fuel resistance, and thermal headroom compared to standard NBR.

Typical range -30°C to +140°C; outstanding ozone, abrasion, and sour-gas resistance.

FKM (Viton / Fluoroelastomer)

Styles: O-rings, rotary lip seals, sheet gaskets

Exceptional resistance to aggressive hydrocarbons, synthetic lubricants, acids, and elevated temperatures.

-20°C to +200°C; avoid high-pressure steam and amine-rich additives unless specialized grade.

Compressed Non-Asbestos Fiber (CNAF)

Styles: Cut sheet pipe flange gaskets (EN 1514 / ASME B16.21)

Aramid/inorganic fibers bonded with NBR elastomer; standard general-utility pipe flange and boiler casing gasket.

Ensure modern non-asbestos grades complying with DIN 3754 / ASME B16.21.

Polyurethane (PU / AU / EU)

Styles: Hydraulic rod & piston seals, wiper scrapers

High tear strength, abrasion resistance, and extrusion resistance for heavy-duty hydraulic cylinder rods and pistons.

-30°C to +90°C; susceptible to hydrolysis in hot water, acids, and strong alkaline media.

Seal Cavity Cross-Section

Gland compression and pressure energization behavior

PSI

Verify gland squeeze (15–30%), lead-in chamfers, and groove surface finish (Ra 0.4–1.6 µm) against manufacturer seal catalogs.

Key Engineering Rules

  • Gland groove depth, diametral clearance gap, and surface roughness (Ra) directly dictate extrusion limits and sealing integrity.
  • In dynamic reciprocating and rotary seals, fluid film lubrication determines lip wear; never operate dry.
  • Consult chemical compatibility matrices for volume swell, hardness change, and elongation loss in contact fluids.
  • Under pulsating high pressure (> 50 bar), incorporate spiral or solid PTFE anti-extrusion back-up rings.

Guides

Related guides

Browse guides with similar tags.

Press-fit tolerance selection and interference fit calculation

Tolerance

ISO 286 tolerance classes, DIN 7190 contact pressure, Lamé thick-walled cylinder equations, assembly press force, and shrink-fit thermal sizing.

Similar calculators

Related calculators

Explore calculators with similar categories or tags.

Basic Heat Flow

Free

Estimate heat flow through a single layer with manual inputs.

Coating Guide

Free

Summary of coating types and corrosion protection.

Fluids & HVAC

Free

Quick calculations for Reynolds, pressure loss, and duct velocity.

Heat Transfer & Energy

Free

Basics for LMTD, conduction, and energy estimates.