Zinc Electroplating (Clear / Yellow Trivalent)
Cost-effective sacrificial cathodic protection for structural steel fasteners and sheet assemblies with bright finish.
Typical thickness: 5–15 µm
Trivalent passivate and sealant required to prevent premature white zinc corrosion.
Hot-Dip Galvanizing (HDG)
Immersion in molten zinc forming thick metallurgical iron-zinc alloy layers; 50+ years outdoor durability in harsh atmospheres.
Typical thickness: 50–100 µm
Heavy coating thickness clogs fine threads; nuts must be tapped oversize after spinning.
Zinc-Nickel Alloy Plating (Zn-Ni)
Automotive benchmark with ~12–15% nickel co-deposition; achieves 1000+ hours neutral salt spray with high thermal stability.
Typical thickness: 8–15 µm
Maintains sacrificial integrity even after prolonged 200°C engine-bay exposure.
Manganese / Zinc Phosphating
Microcrystalline conversion layer providing excellent oil retention for moving joints and strong primer adhesion for powder coating.
Typical thickness: 2–15 µm
Manganese phosphate excels for anti-galling run-in wear; zinc phosphate is standard paint pre-treatment.
PTFE / MoS2 Solid Film Lubricant (Xylan / Everlube)
Bonded fluoropolymer/moly dry film for vacuum, cleanroom, or extreme load joints where liquid oils evaporate or attract dust.
Typical thickness: 10–25 µm
Eliminates thread galling on stainless steel studs and deep subsea fasteners.
Electroless Nickel Plating (ENP / High-Phos Ni-P)
Autocatalytic chemical reduction providing 100% uniform thickness on blind bores, threads, and complex internal fluid channels.
Typical thickness: 10–35 µm
High-phosphorus (10–13% P) grades offer superior pinhole-free barrier corrosion; bakeable to 68 HRC.
Electroless Nickel + PTFE Co-deposit (EN-PTFE)
Sub-micron PTFE particles co-deposited within nickel matrix; self-lubricating non-stick surface with excellent release properties.
Typical thickness: 15–25 µm
Tin Plating (Matte / Bright over Copper)
Protects electrical copper busbars from atmospheric oxidation while preserving excellent solderability and contact conductivity.
Matte tin with nickel underplate is preferred to inhibit conductive tin whisker growth in electronic busbars.
Cerakote Thin-Film Ceramic Polymer
Thin-film oven-cured ceramic composite formulation with unmatched chemical resistance, hydrophobic barrier, and custom tactical colors.
Does not interfere with delicate mechanisms (~25 µm build); requires precise surface profile grit blasting.
Industrial Hard Chrome Plating
Heavy micro-cracked electroplated chromium (65–70 HRC) for hydraulic piston rods, mining rams, and print rollers.
Typical thickness: 20–100 µm
Mandatory de-embrittlement bake on high-tensile steels; increasingly substituted by HVOF due to Cr(VI) environmental laws.
HVOF Thermal Spray Carbide (WC-10Co-4Cr)
Supersonic thermal spray deposition of tungsten carbide particles; extreme cavitation and abrasive slurry resistance for subsea valves.
Requires post-spray diamond grinding and superfinishing to achieve mirror sealing surfaces.